sidebar lampesimulator

Send us an email with your order: order@raco.dk

Light bulb simulation/load fot LED lights 12V

Skema 11713 GB 002lampesimulator 11713 001

 

 

 




Designed for cars that pull trailers with LED lights.

Light bulb simulation makes it possible to combine trailers equipped with LED lights to the light bulb systems of different towing vehicles.
In most of the vehicles the flash light will demand a great load, also the CAN-Bus demands great load, but the LED lights on the trailer demands very little load, the result is that various problems may arise, when the trailer is connected to the vehicle.
EACO and G.S.E has solved this urgently problem with the new Light bulb simulation.

Mounting:
The unit must be mounted on the trailer, but only trailers with LED lights. Mounting the unit on trailers with bulb lights will result in overload of the vehicle.
The light bulb simulation must be mounted outside because the unit will grow very warm. Must be mounted on heat-conducting metal item, with free air circulation as possible.

Connection: The connections are bidirectional and may therefore be exchanged.

The light bulb simulation is available in 3 versions:

  • Order no. 11700 is equipped with free cable.
  • Order no. 11707 is equipped with 7 pin plug and socket.
  • Order no. 11713 is equipped with 13 pin plug and socket.

Light bulb simulation no 11700 series has been developed to be compatible with all known vehicles, but vehicle manufactures frequently modify the functions, therefore RACO and G.S.E cannot guarantee for unknown problems.

lampesimulator 11700 001Light bulb simulation/load for LED lights with free cable ends

Order no. 11700

The light bulb simulation 11700 is without plug and socket.
The light bulb simulation is equipped with a temperature fuse in the stop light and fog light. After overload, it turns on again after approx. 30 min.

  • Free cable ends
  • Volt: 12V
  • It is waterproof: IP65
  • Dimensions: 190mm X 110mm X 42mm

Can be mounted with 4 pieces. 5mm screws.
Comes with approx. 1.5 m long cable that connects the car and an approx. 40cm short cable for internal connection to the trailer.

lampesimulator 11713 001Light bulb simulation/load for LED lights with 13 pin plug and socket

Order no. 11713

The light bulb simulation 11713 is with 13 pin plug and 13 pin socket.
The light bulb simulation is equipped with a temperature fuse in the stop light and fog light. After overload, it turns on again after approx. 30 min.

  • 13 pin plug and socket
  • Volt: 12V
  • It is waterproof: IP65
  • Dimensions: 190mm X 110mm X 42mm

Can be mounted with 4 pieces. 5mm screws.
Comes with approx. 1.5 m long cable that connects the car and an approx. 40cm short cable for internal connection to the trailer.

gse raco gb

Send us an email with your order: order@raco.dk